Table of Contents
Advertisement
Operation
^ Confirm the selection by touching the
Charcoal filter sensor |.
All the sensors will go out.
If you do not confirm within 4 minutes,
the cooker hood will automatically
revert to the original setting.
Checking the charcoal filter
operating hours counter
To check the percentage of time set
already used:
^ Touch the On/Off sensor s to switch
the fan on.
^ Touch and keep your finger on the
Charcoal filter sensor |.
One or more of sensors 1 to 4 will flash.
The number of flashing sensors
indicates the percentage of the
operating time which has already been
used up.
Sensor 1
Sensors 1 and 2 = 50 %
Sensors 1 to 3
Sensors 1 to 4
The number of operating hours used
remains in the memory, even when the
appliance is switched off or there is a
power cut.
16
= 25 %
= 75 %
= 100 %
Sensor tones
When selecting a function with the
sensors, an audible tone will sound
briefly to confirm.
The audible tone can be deactivated.
^ Touch the On/Off sensor s to switch
the fan off.
^ Touch the 4 sensor and the Grease
filter sensor l at the same time for
approx. 5 seconds until a tone
sounds briefly. The audible tone is
now switched off for all functions.
^ To reactivate the audible tone, repeat
the above process.
After the cooker hood has been
disconnected from the mains electricity
supply or after a power cut, the audible
tone is activated regardless of the last
setting.
Safety switch-off after 10 hours
Should the cooker hood be left on, the
fan will switch off automatically after 10
hours.
The hob lighting will remain on.
^ You can switch the fan on again by
touching the On/Off sensor s.
Advertisement
Table of Contents
