Klarstein 10040285 Manual page 30

EN
30
Emergencies
Grease fire or continuous
excessive flames above
cooking surface
Burner will not light
using ignitor
Burner will not light
using ignitor
(electrical issues)
Possible cause
Too much grease
buildup in burner area
No gas flow
Vapor lock at coupling
nut to LP tank
Coupling nut ad LP tank
valve not fully connected.
Electrode cracked or
broken; sparks at crack.
Electrode tip not in
proper position.
Wire and/or
electrode covered with
cooking residue
Wires are shorting
(sparking) between
igitor and electrode.
Wires are shorting
(sparking) between
ignitor and electrode:
Push button sticks at
bottom sparking between
ignitor and electrode
Prevention/ Solution
Turn off LP Tank. Leave lid
open to allow flames to
die down. After cooling,
clean food particles
and excess grease from
inside firebox area,
grease cup/pan/tray,
and other surfaces.
Make sure LP tank is not
empty. If LP tank is not
empty, refer to "sudden
drop in gas flow".
Turn off knobs and
disconnect coupling
nut from LP tank.
Reconnect and retry.
Turn the coupling nut
approximately one-
half to three-quarters
Replace electrode.
Tip of electrode should be
pointing toward port hole
in burner. The distance
should be 1/8'' to 3/16''.
Adjust if necessary.
Clean wire and or
electrode with rubbing
alcohol and clean swab.
Reconnect wires or
replace electrode/
wire assembly.
Replace ignitor wire.
Inspect wire insulation
and proper connection.
Replace wires if
insulation is broken.