Resetting On The Pin Code Reader; Signalling Of The Rfid Reader - Simons Voss Technologies PegaSys Wall reader stainless steel/pin code 2.1 Quick Start Manual

8. Resetting on the PIN code reader

8 Resetting on the PIN code reader
9 Signalling of wall reader 2.1/4.1

9.1 Signalling of the RFID reader

Optical signal
1x blue flashing
28 / 64
2. Reconnect the power supply.
Reset phase starts. LED lights up orange for 10
9
s.
3. Press and hold the reset button.
LED lights up red.
9
4. Release the reset button.
Reset starts.
9
9 LED lights up purple for a few seconds.
Wall reader 2.1 stainless steel reset.
9
The entire code memory is deleted and all pre-set
codes (see Pin code quick guide) are active again.
10
1. Open the housing.
2. Press and hold the reset button for approx. 15
seconds.
LED flashes orange-red.
9
9 LED flashes green and reader beeps.
3. Close the housing again.
9 Reset complete.
stainless steel
Acoustic signal
PegaSys Wall reader stainless steel/
Description
Search and read
badge
pin code 2.1/4.1
EN