How To Program Your Jmx/ Sst - Ritron Jobcom JMX-152 Owner's Manual

To match other radios, the owner can select FREQUENCY and QUIET CALL TONE CODES from tables factory-programmed
into the radio. See Tables 1 and 2, page 5.
1. Choose your frequency codes (Table 1), and QC codes, if desired (Table 2). Programming channel 2 is optional. Note that
each code consists of two digits. Write down the digits of the codes you are going to program in the space provided below.
CHANNEL 1:
1st
digit
CHANNEL 2:
5th
digit
2. Follow the instructions in FIG-4, page 4, to place the radio in the Program/ Readout Mode.
3. Enter codes in the sequence shown in Step 1 by clicking the PTT the number of times equal to each digit of the code.
EXAMPLE: Two-digit code "04" — click the PTT ten times to program "0", and pause. The radio emits a low tone.
4. When all the digits are programmed, press and release On/ Volume Up to save your programming; the radio emits a triple beep.
NOTE: An error tone will sound if you attempt to save an incorrect digit. Turn the radio off, check the digits you are attempting
5. Turn the radio off and then on again — the radio is now ready to use
NOTES: 1. Ten (10) PTT clicks = 0 (zero).
2. Program "44" to enter "No Code" for Quiet Call. You must enter "44" to match radios not having tone codes.
3. IF YOU MAKE A PTT CLICK ERROR, turn the radio off then on, and start over.
4. If the radio does not emit a confirming triple tone when you attempt to enter Program/ Readout Mode, the radio was
factory or dealer customized to disable programming. Consult the radio owner or your dealer.
5. Refer to Frequency and Tone Code (Quiet Call®) tables on page 5.
* The radio pauses to emit a low tone at the end of each beep series.
page 3 RITRON, INC. 1-800-USA-1-USA (1-800-872-1872)
page 6

HOW TO PROGRAM YOUR JMX/ SST

Frequency Code
Pause; 2nd
digit
radio emits
# of PTT # of PTT
a low tone. *
clicks clicks
Frequency Code
6th
Pause;
digit
radio emits
# of PTT # of PTT
a low tone.
*
clicks clicks
Then click the PTT four times to program "4", and pause. The radio emits a low tone.
to enter, then start over at Step 2.
For assistance, call 800-USA-1-USA
ANNEL 1:
Tone Code
Pause; 3rd Pause;
digit
radio emits radio emits
# of PTT
a low tone. * a low tone.
clicks
ANNEL 1:
Tone Code
7th
Pause; Pause;
digit
radio emits radio emits
# of PTT
a low tone. a low tone.
*
clicks
800-USA-1-USA 800-USA-1-USA 800-USA-1-USA 800-USA-1-USA (800-872-1872)
4th Pause;
digit
radio emits
# of PTT
* a low tone. *
clicks
8th
Pause;
digit
radio emits
# of PTT
a low tone.
* *
clicks
Continue the programming
sequence if you are entering
digits for Channel 2.