Mitsubishi Electric MSZ-AP20VG-E3 Service Manual page 13

8-4. Wi-Fi INTERFACE SETTING UP (MSZ-AP·VGK)
This Wi-Fi interface communicates the status information and controls
the commands from the MELCloud by connecting to an indoor unit.
Wi-Fi cover
Wi-Fi interface
Wi-Fi interface introduction
No. Item
1 MODE switch It selects modes.
2 RESET switch It resets the system and ALL settings.
3 ERR LED (Orange) It shows the network error state.
4 NET LED (Green) It shows the network state.
5 MODE LED (Orange) It shows the Access point mode state.
6 UNIT LED (Green) It shows the indoor unit state.
3
4
5
ERR
NET
6
MODE
UNIT
RESET MODE
2 1
(1) MODE switch
• The MODE switch is used for selecting modes in configurations.
(2) RESET switch
• Hold down the RESET switch for 2 seconds to reboot the system.
• Hold down the RESET switch for 14 seconds to initialize the Wi-Fi
interface to the factory default.
NOTE:
When the Wi-Fi interface is reset to the factory default, ALL the
configuration information will be lost. Take great care in implementing
this operation.
OBH838C
Front panel
Front panel
Description
INTERFACE
Wi-Fi
MODEL XXXXXXXX
MAC : XXXXXXXXXXXX
ID : XXXXXXXXXX
SSID : XXXXXXXXXXXX
KEY : XXXXXXXXXXXX
VOLTAGE :
:
CURRENT
MITSUBISHI ELECTRIC CORPRATION
>PP<
WiFi.ASSY DWG No.
XXXXXXXXXXX
MADE IN CHINA XXXXXXXXXX
(1) Open the front panel and the Wi-Fi cover.
(2) Set up a connection between the Wi-Fi interface and the router.
Refer to the SETUP MANUAL and SETUP QUICK
REFERENCE GUIDE provided with the unit.
For SETUP MANUAL, please go to the website below.
https://www.melcloud.com/Support
(3) Close the Wi-Fi cover and the front panel after the setup
is completed.
(4) For MELCloud User Manual, please go to the website below.
https://www.melcloud.com/Support
NOTE:
• Ensure that the Router supports the WPA2-AES encryption setting before
starting the Wi-Fi interface setup.
• The End user should read and accept the terms and conditions of the Wi-Fi
service before using this Wi-Fi interface.
• To complete connection of this Wi-Fi interface to the Wi-Fi service, the Rout-
er may be required.
• This Wi-Fi interface will not commence transmission of any operational data
from the system until the End user registers and accepts the terms and con-
ditions of the Wi-Fi service.
• This Wi-Fi interface should not be installed and connected to any Mitsubishi
Electric system which is to provide application critical cooling or heating.
• At the time of relocation or disposal, reset the Wi-Fi interface to the factory
default.
Mitsubishi Electric's Wi-Fi interface is designed for communication to Mit-
subishi Electric's MELCloud Wi-Fi service.
Third party Wi-Fi interfaces cannot be connected to MELCloud.
Mitsubishi Electric is not responsible for any (i) under performance of a sys-
tem or any product; (ii) system or product fault; or (iii) loss or damage to any
system or product; which is caused by or arises from connection to and/or use
of any third party Wi-Fi interface or any third party Wi-Fi service with Mitsubishi
Electric equipment.
For the latest information regarding MELCloud from Mitsubishi Electric
Corporation, please visit www.MELCloud.com.
13