Table of Contents
Advertisement
Quick Links
Operating instructions
Baby scale
KERN MBE
Version 2.0
2018-01
GB
KERN & Sohn GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: info@kern-sohn.com
Tel: +49-[0]7433- 9933-0
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Importør:
Impex Produkter AS
Gamle Drammensvei 107
1363 Høvik
www.impex.no
info@impex.no
Tel.: 22 32 77 20
MBE-BA-e-1820
Advertisement
Table of Contents
Related Manuals for KERN&SOHN MBE-BA-e-1820
Summary of Contents for KERN&SOHN MBE-BA-e-1820
- Page 1 KERN & Sohn GmbH Ziegelei 1 Tel: +49-[0]7433- 9933-0 D-72336 Balingen Fax: +49-[0]7433-9933-149 E-Mail: info@kern-sohn.com Internet: www.kern-sohn.com Operating instructions Baby scale KERN MBE Version 2.0 Importør: 2018-01 Impex Produkter AS Gamle Drammensvei 107 1363 Høvik www.impex.no info@impex.no Tel.: 22 32 77 20 MBE-BA-e-1820...
-
Page 2: Table Of Contents
Changing weight unit ....................8 Operation ......................9 Display ........................9 Handling ........................9 Using the scale ....................9 Error messages ....................10 Service, maintenance, disposal ..............10 10.1 Cleaning ........................10 10.2 Service, maintenance .....................10 10.3 Disposal ........................10 Troubleshooting................... 11 MBE-BA-e-1820... -
Page 3: Technical Data
After 2 min without load change Air humidity max. 80% (non-condensing) Scale ready for weighing 560 x 350 x 88 mm (W x D x H) mm Scale plate mm 480 x 270 mm Total weight kg (net) 2.0 kg MBE-BA-e-1820... -
Page 4: Declaration Of Conformity
“stability compensation“ in the scale! (Example: Slowly draining fluids from a container on the scale.) Do not leave a permanent load on the weighing plate. This can damage the measur- ing equipment. MBE-BA-e-1820... -
Page 5: Guarantee
4.1 Observing the directions included in the Operating Instructions Please read these Operating Instructions carefully before erecting and commission- ing the balance, even if you already have experience with KERN balances. 4.2 Staff training The device may only be operated and maintained by trained members of staff. MBE-BA-e-1820... -
Page 6: Transport And Storage
Avoid static charge build-up on the scale and people to be weighed; Avoid contact with water. Major display deviations (incorrect weighing results) are possible if electromagnetic fields occur as well as due to static charging and instable power supply. It is neces- sary then to change the scale location. MBE-BA-e-1820... -
Page 7: Unpacking
(refer to „Warm-up time”, chapter 1). During the warm-up time, the scale must be switched on. The accuracy of the scale depends on the local acceleration of the fall. Please be sure to observe the information included in the chapter on „Adjustment”. MBE-BA-e-1820... -
Page 8: Adjustment
At the back of the scale (next to the battery compartment) there is the small slide switch which you can use to change weight units between kg and lb. When a change is carried out, the display will show the present active weight unit (kg or lb:oz) MBE-BA-e-1820... -
Page 9: Operation
When the scale is switched on, 0.00 value will be displayed and the weight, which was lying on the scale pan before its switching on, will be tared. MBE-BA-e-1820... -
Page 10: Error Messages
The device may only be operated and maintained by trained service technicians who are authorised by KERN. 10.3 Disposal Disposal of packaging and device must be carried out by an operator according to valid national or regional law of the location where the device is used. MBE-BA-e-1820... -
Page 11: Troubleshooting
• Electromagnetic fields/static charging (choose a different location for the scale, switch off an inter- fering device if possible) Should other error messages occur, switch the scale off and then on again. If the er- ror message remains, inform the manufacturer. MBE-BA-e-1820...
Need help?
Do you have a question about the MBE-BA-e-1820 and is the answer not in the manual?
Questions and answers