Fixed Antennas; Led Indicators - Bluesocket BlueSecure 1500 Installation Manual

Fixed Antennas

The BSAP includes two omni-directional antennas for wireless communications.
The antennas support diversity whereby the signal transmitted from both antennas
is identical, but only the best signal received on one of the antennas is used. The
antennas transmit the outgoing signal along a horizontal plane perpendicular to
the antenna (in the shape of a toroidal sphere). Therefore, you may want to
position the antennas in a range of 45 to 90 degrees from each other to provide
better coverage.

LED Indicators

The BSAP provides four
status light-emitting diodes
(LEDs). These status LEDs
are illustrated at right and
described in Table 1.
PWR
Ethernet Link
.11a
.11b/g
BlueSecure™ Access Point 1500 Installation Guide
Table 1: BSAP Status LEDs
LED Status
On
Flashing
Flashing
(Prolonged)
On
Flashing
On
Very Slow
Flashing
Slow
Flashing
Fast Flashing
On
Very Slow
Flashing
Slow
Flashing
Fast Flashing
Familiarizing Yourself with the BSAP Hardware
Power Ethernet
Link/Activity
Power is supplied to the BSAP
Self-test is running, or firmware is being loaded
System Errors
Valid 10/100 Mbps Ethernet link
Data activity on Ethernet link
Valid 802.11a wireless link
Searching for 802.11a network association
Associated with 802.11a network but no activity
BSAP is transmitting/receiving data on its 802.11a
wireless link
Valid 802.11b or 802.11g wireless link
Searching for 802.11b/g network association
Associated with 802.11b/g network but no activity
BSAP is transmitting/receiving data on its 802.11b/g
wireless link
802.11a 802.11b/g
Link/Activity Link/Activity
Indicates
3