Setting The Bsap And Home Bsc Ip Addresses Using The Cli - Bluesocket BlueSecure 1500 Installation Manual

The two options for IP address mode are:
• (0) DHCP - The BSAP runs a DHCP client and receives its IP address from a
DHCP server.
• (1) Static IP - You assign the BSAP a static IP address via its CLI.
The two options for WG address mode are:
• (0) Discover - The BSAP automatically discovers the IP address of the BSC to
which it is to connect.
• (1) Static Configuration - Using the BSAP CLI, you will configure the IP
address of the BSC to which the BSAP is to connect.

Setting the BSAP and Home BSC IP Addresses Using the CLI

To set the BSAP and Home BSC IP addresses using the CLI:
Enter 1 at the BSAP CLI main menu command prompt.
1.
The BSAP CLI network configuration menu appears as shown in Figure 6.
Enter 1 at the Network Cfg prompt to set the IP address mode.
2.
Enter 1 to set the BSAP IP address mode to static.
Enter 2 at the Network Cfg prompt to set the BSAP's IP address.
3.
Enter the BSAP IP address and subnet mask using the format:
<address> netmask <netmask>
Enter 3 at the Network Cfg prompt to specify the BSAP's default IP gateway.
4.
Enter 4 at the Network Cfg prompt to specify the IP address of the BSAP's
5.
primary DNS server.
BlueSecure™ Access Point 1500 Installation Guide
Figure 6: BSAP CLI Network Configuration Menu
Using the BSAP Command Line Interface (CLI)
11