Table of Contents
Advertisement
Manual ACM 9 - ARE i9 release
5. FCC Statement
5.1 ACM 9
Valid for ACM 9 – EtherCAT, ACM 9 – Profinet, ACM 9 – Ethernet/IP
Federal Communications Commissions (FCC) Statement
§15.21
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user's authority to operate the equipment.
§15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
5.2 ARE i9
Valid for ARE i9 – LF, ARE i9 –hdx - SEMI, ARE i9 - HF
Federal Communications Commissions (FCC) Statement
§15.21
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user's authority to operate the equipment.
§15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
6. Release, Change Protocol
Revision:
Date:
01
21.09.2020
02
29.09.2020
03
12.10.2020
04
22.11.2020
05
09.12.2020
06
06.01.2021
07
16.03.2021
08
23.03.2021
09
20.10.2021
10
17.10.2022
Manual ACM9_ARE i9 release V10.docx
Changes:
Release first edition
Details added
Details added
Details added
FCC statement added
ACM 9 serial interface description added
EtherCAT nomenclature changed, Description files clarification
EtherCAT license statement updated
Read range for space contraints added
ARE i9x section added
Version: 10
Page: 50 / 51
Author:
NK
NK
NK
NK
NK
NK
NK
NK
NK
NK
Advertisement
Table of Contents
