Advertisement
Available languages
Available languages
To replace the blade
1. Lock the blade with a block of wood.
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see if
there are damages.
5. Examine the engine shaft to make sure that it is not
bent.
6. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting cover.
Problem
The engine does not start.
The engine does not stop.
14
Troubleshooting
Possible cause
The ignition cable is not connec-
ted correctly.
The fuel tank is empty.
There is dirt in the carburetor or
fuel line.
The spark plug is defective.
The stop mechanism is defective. Disconnect the ignition cable from the spark
7. Make sure that the blade is aligned with the center of
the engine shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer with a
torque of 47-54 Nm.
9. Pull the blade around by hand and make sure that it
turns freely.
WARNING: Use heavy duty gloves. The
blade is very sharp and cuts can easily
occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
Solution
Connect the ignition cable to the spark plug.
Fill the fuel tank with correct fuel type.
Clean the carburetor and/or fuel line.
Adjust the electrode gap, clean or replace
the spark plug.
plug. Let an approved service agent repair
the product.
1219 - 002 - 08.07.2019
Advertisement
