Entering New Timings; Power Saving Function - Sony Trinitron Multiscan15sf II Operating Instructions Manual

Setteing the color temperature
The selected color temperature becomes the common setting
for all input signals.
1
Press COLOR button.
The "COLOR TEMPERATURE" OSD appears.
COLOR
VAR I ABLE
2
Adjust with the ¨ ?// and > >/. buttons.
To select 5000K or 9300K
Press ¨ ?// buttons.
The selected color temperature is indicated in yellow.
? . . . to select 5000K
/ . . . to select 9300K
To obtain the desired color temperature between 5000K
and 9300K
Press > >/. buttons.
> . . . for higher temperature
. . . . for lower temperature
Your most recent adjusted color temperature will be
recalled by pressing > >/. button.
To erase the "COLOR TEMPERATURE" OSD, press the
COLOR button again.
The "COLOR TEMPERATURE" OSD automatically
disappears 20 seconds after you release the buttons.
Resetting
• Press the RESET button to recall the factory settings for
brightness, contrast, horizontal and vertical size, center
and pincushion for the mode currently in use.
• Press and hold the RESET button for 2 seconds to recall
factory setting for all adjustments in all modes.
RESET
COLOR TEMPERATURE
5000K 9300K
5 0

Entering New Timings

When using a video mode that is not one of the 6 factory
preset modes, some fine tuning may be required to optimize
the display to your preferences. Simply adjust the monitor
according to the preceding adjustment instructions. The
adjustments will be stored automatically and recalled
whenever that mode is used.
A total of 10 user-defined modes can be stored in memory.
If the 11th mode is entered, it will replace the first.

Power Saving Function

This monitor meets the power saving guidelines set by the
EPA Energy Star Program as well as the more stringent
NUTEK 803299 (TCO92) guidelines. It is capable of reduced
power consumption when used with a computer equipped
with Display Power Management Signaling (DPMS). By
sensing the absence of the sync signal coming from the
computer, it will reduce the power consumption as follows:
CAUTION: The Power Saving function will automatically
put the monitor into Active-off state if the power
switch is turned on without any video signal
input. Once the horizontal and vertical syncs are
sensed, the monitor will automatically return to
its Normal operation state.
Required
Power
State resumption
consumption
Normal
1 100%
operation
Suspend
approx. approx.
2 (1st step of
10%
power saving)
CPD-15SF2:
Active-off
approx. 7%
approx.
3 (2nd step of
CPD-17SF2:
power saving)
approx. 6%
POWER
u Power
SAVING
indicator
time indicator
— green on off
green on orange on
3 sec.
off orange on
10 sec.
7
EN