Entering New Timings; Power Saving Function; Plug And Play; Use Of The Tilt-Swivel - Sony CPD-100SFT Operating Instructions Manual

Entering New Timings

When using a video mode that is not one of the factory
preset modes, some fine tuning may be required to optimize
the display to your preferences. Simply adjust the monitor
according to the preceding adjustment instructions. The
adjustments will be stored automatically and recalled
whenever that mode is used.
A total of 10 user-defined modes can be stored in memory.
If the 11th mode is entered, it will replace the first.

Power Saving Function

This monitor meets the power saving guidelines set by the
E S
International NERGY TAR Program as well as the more
stringent TCO92 803299 (NUTEK) guidelines. It is capable
of reduced power consumption when used with a computer
equipped with Display Power Management Signaling
(DPMS). By sensing the absence of the sync signal coming
from the computer, it will reduce the power consumption as
follows:
CAUTION: The Power Saving function will automatically
put the monitor into Active-off state if the power
switch is turned on without any video signal
input. Once the horizontal and vertical syncs are
sensed, the monitor will automatically return to
its Normal operation state.
Power
State
consumption
Normal
1
100%
operation
Suspend
approx.
2
(1st step of
10%
power saving)
Active-off
3 (2nd step of
approx. 7%
power saving)
4 Power-off
approx. 7%
If you want the power consumption to be 0W, unplug the
power cord.
8
u
Required POWER
resumption POWER SAVING
time indicator indicator
— green on off
approx.
green on orange on
3 sec.
approx.
off orange on
10 sec.
– off off

Plug and Play

This monitor complies with the DDC
and DDC2B+ which are the Display Data Channel (DDC)
standards of VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
When a DDC2B, DDC2AB or DDC2B+ host system is
connected, the monitor automatically switches to each
communication.
TM
DDC is a trademark of Video Electronics Standard
Association.

Use of the Tilt-Swivel

With the tilt-swivel, this unit can be adjusted to be viewed at
your desired angle within 90˚ horizontally and 20˚ vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands.
15°
45°
5°

Damper Wire

Using a white background, very thin horizontal stripes on
the screen are visible as shown on the illustration. These
stripes are damper wires. These wires are attached to the
aperture grille inside the Trinitron tube and are there to
damp vibrations of the aperture grille in order to prevent
them from influencing to the picture quality.
Damper wire
TM 1, DDC2B, DDC2AB
45°
Approx. 6 cm
(CPD-200SFT
only)
Approx. 6 cm