Advertisement
2
4
Figure 49
1. Hairpin cotter and washer
2. Long rod
6.
Now check the front-to-rear blade slope; refer to
Front-to-Rear Blade Slope, page 43.
Front-to-Rear Blade Slope
Check the front-to-rear blade slope any time you
install the mower. Before you check the slope, set the
air pressure in the front and rear tires to the
recommended inflation. Refer "Tire Pressure"
(page 23 ) in the Maintenance Section. If the front of
the mower is not within a range of 1/8"–3/8" (3.5
mm–10.5 mm) lower than the rear of the mower,
adjust the blade slope using the following
instructions:
1.
Park the machine on a level surface, disengage
the blade control (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine.
2.
Remove the key from the ignition switch and
pull the wire off the spark plug.
1
1
3
1805
3. Leveling bracket
4. Mower mount
3.
Check and adjust side-to-side blade level if you
have not checked the setting; refer to
Side-to-Side Mower Leveling, page 42.
4.
Move the height-of-cut lever (deck lift) into the
"C" notch.
5.
Measure the length of the rod extending out the
front of the adjusting block on the sides of the
chassis (Fig. 50). If the rod length is not 5/8"
(15.9 mm), remove the hair pin cotter and
washer from the end of the rod (Fig. 50), and
turn the rod until the 5/8" (15.9 mm) dimension
is obtained. Then install the end of the rod into
the hole in the mower mount and secure in place
with washer and hair pin cotter. Repeat this
procedure on the opposite side of the mower.
6.
Check the front to rear slope by measuring
between the bottom of the mower
(front center and rear center) and the flat surface
(Fig. 51). If the front is not within a range of
1/8"–3/8" (3.5mm–10.5mm) lower than the rear,
an adjustment is required.
Maintenance
43
Advertisement
