Advertisement
IMPORTANT: If the engine does not start
after 30 seconds of continuous cranking, turn
the ignition key to "OFF" and let the starter
motor cool; refer to Troubleshooting, page 47.
6.
After the engine starts, slowly move the throttle
lever to "FAST" (Fig. 8). If the engine stalls or
hesitates, move the throttle lever back to
"CHOKE" for a few seconds. Then move the
throttle lever to "FAST." Repeat this as required.
2
1
1852
3
Figure 7
1. Disengaged
2. Engaged
3. Blade control (PTO)
3
Figure 9
1. Start
2. On
3. Off
Stopping
1.
Move the throttle lever to "SLOW" (Fig. 8).
2.
Turn the ignition key to "OFF" (Fig. 9).
1
2
3
1859
Figure 8
1. Choke
2. Fast
3. Slow
2
1
Note:
If the engine has been working hard or
is hot, let it idle for a minute before
turning the ignition key "OFF." This
helps cool the engine before it is
stopped. In an emergency, the engine
may be stopped by turning the ignition
key to "OFF."
Operation
15
Advertisement
