Mounting Your Rw 400; Attaching The Mount - RightWay RW400 User Manual

MOUNTING YOUR RW 400

Your RW 400 GPS Navigator can be easily secured to either the windshield or the dash for optimal
viewing while driving. The mounting system consists of the following pieces:

Adjustable arm with suction cup

Navigator cradle

Dash disk with adhesive backing

ATTACHING THE MOUNT

1. Select a location for the mount on the windshield or dashboard that does not
obstruct the driver‟s view or interfere with the operation of the vehicle.
2. Clean and dry this area to remove any grease and dirt.
If mounting the RW Navigator on the dashboard, remove the protective
backing from the dash disc, exposing the adhesive. Adhere the disc to the
dashboard in the desired location.
3. Place the suction cup on the desired location on the windshield or
dash disc; push the locking lever towards the base of the mount.
The mount should stick to the surface.
If your mount does not stick, make sure the area is clean and
dry, then try again.
4. Align the tabs on the holder with the slots on the Navigator cradle.
Slide together until you feel a firm click.
5. Adjust the holder to the best viewing angle by:
a. Loosening the adjustor dials
b. Moving the corresponding part to the desired position
c. Tightening the adjustor dials.
The adhesive is permanent.
Locking Lever
7