Edit Your Road Preferences; Checking The Gps Status; Adjusting Your Safety View - RightWay RW400 User Manual

EDIT YOUR ROAD PREFERENCES

After a routing profile has been added, you may view Edit Road Preferences.
Scroll to the bottom of the page and tap View/Edit Road Preferences. The available
settings are:

For each road type: Choose whether you want to Strongly Avoid,
Avoid, Neutral, Favor or Strongly Favor when choosing a route.

Speed: Select an appropriate speed for each road, you can increase or
decrease the speed in increments of 5.
Note: It is not recommended to change the default route and road preferences as
this will affect the route calculated and ETA shown.

CHECKING THE GPS STATUS

Tap Menu > Settings > GPS > GPS Status.
The GPS Status screen shows detailed information regarding the GPS fix and signal
strength your RW 400 uses for guidance.
From this screen you can see your current latitude and longitude position, the UTC
time and date, your speed and your elevation (feet above sea level).

ADJUSTING YOUR SAFETY VIEW

Tap Menu > Settings > Next> Driver Safety. From here you can alter the settings of
the Safety View in the following ways:

Display Map Near Turns: Decide whether to show a 2D/3D zoomed
map on the approach to each turn or always show the Driver Safety
screen. Check the box for Yes to display the map or No not to.

When the Turn is Within: If you selected Yes above, choose the
distance before the turn you would like the map to be displayed. The
distance can be set between 0.3 miles and 1 mile.

Map Type: If Display Map Near Turns is set to Yes, select whether to
use a 2D or 3D map when approaching turns.

Tap OK to save your new settings and exit. Tap Cancel to discard your
changes.
37