Advertisement
Hardware Installation
Step 7. Completing the Installation
1.
Replace any adapters removed earlier.
2.
The TurboChip
management. Therefore, there are no special voltage settings required
on the motherboard or the TurboChip 400
3.
The TurboChip
multiplier to run at 400MHz of processing power with 66MHz
external bus speed. The TurboChip
upgrade. Depending on the clock frequency of your original
processor, the external bus frequency may have a variety of settings.
It would be recommended to use the 66MHz external bus speed for
full performance. (Note: some systems may require a lower bus
frequency (e.g. 60MHz) to operate correctly.
External Bus Speed
4.
Reconnect any cables, power cord, keyboard, mouse, etc...
5.
Check that your computer starts correctly. It should begin a memory
count and run its POST (Power-On-Self-Test). If it does not boot,
turn to "Appendix B Troubleshooting" in the back of this manual for
help.
6.
If the computer starts correctly then replace the cover.
Congratulations! The installation is now complete. Because TurboChip
requires no device drivers, there is no software installation to perform. If you
experience any problems, refer to "Appendix B Troubleshooting". If your
problem is beyond the scope of this manual or you have questions regarding
this product, call Kingston Technical Support (refer to "Appendix E Warranties
and Notices" for information on how to reach us).
®
TurboChip
400 User's Guide - Rev. A00
®
400 is designed with independent voltage
®
400 is equipped with a 6.0x internal clock
50MHz
60MHz
66MHz
®
.
®
400 is a simple plug-and-play
Clock Multiplier
6.0x
6.0x
6.0x
Kingston Technology Company
Processing Speed
300MHz
366MHz
400MHz
9
®
Advertisement
