Samsung WF50BG83 A Series User Manual page 34

Operations
05 Spin
06 Soil
07 Pre Soak
08 Super Speed
09 Smart Care
10 Delay End
11 Alarm Off
34 English
Untitled-3 34
Press to change the spinning speed for the current cycle.
• High (Level 5): Extends the spinning process to effectively remove
moisture from the load. This level uses a stronger spinning process to
remove moisture, so it is not suitable for wrinkle-free or non-iron fabrics, or
overloads.
• (Level 4): Underwear, t-shirts, jeans, and sturdy cottons.
• (Level 3): Jeans, wrinkle-free or wash-and-wear items, and synthetics.
• (Level 2): Delicate items that require a lower spinning speed.
• No Spin (Level 1): The drum does not spin after the final drain process.
Rinse hold (All indicators are off): The final rinse process is suspended so that
the laundry remains in the water. To unload the laundry, run a drain or spin
process.
NOTE
Spin Only: To perform the spin process only, press and hold Spin for 3 seconds.
With the cycle time on the display, press Spin repeatedly until a desired
spinning speed is selected. Then, press and hold Start/Pause (Hold to Start) to
start.
Press to change the soil level for the current cycle.
• Heavy (Level 5): For extremely soiled loads.
• (Level 4): For heavily soiled loads.
• (Level 3): For moderately soiled loads. This setting is best for most loads.
• (Level 2): For lightly soiled loads.
• Light (Level 1): For barely soiled loads.
Press to add 30 minutes of soaking time at the start of the wash cycle for better
stain removal.
Press this button if you need to shorten the washing time, applicable for
NORMAL, HEAVY DUTY, BEDDING or STEAM WHITES. The shortened time may
differ depending on the selected cycle/load/options.
This function enables you to check the status of the washer using a smartphone.
Set the washer to finish your wash automatically at later time. Choose a delay of
between 1 to 24 hours (in 1 hour increments). (For more information about Delay
End, see page 40.)
Press to turn the alarm sound on or off. When the alarm is off, the cycle
completion melody and the power-off beep will not sound. However, button and
alert sounds will remain on.
2022-06-10 4:12:06