Download Print this page

Huawei WATCH 4 Series Manual page 31

Hide thumbs Also See for WATCH 4 Series:

Advertisement

1
Wear your wearable device in the correct manner, and keep your arm still.
2
Press the Up button on your wearable device to enter the app list, swipe up or down on
the screen until you see SpO2 (
3
For certain products, you'll need to touch Measure. The actual product interface shall
prevail.
4
Remember to keep still with the screen facing upwards, during SpO2 measurements.
Enabling/Disabling Automatic SpO2 measurement
1
Open the Huawei Health app, touch Devices then the name of your connected device,
and enter its details screen. Touch Health monitoring, and enable/disable Automatic
SpO₂.
2
Touch Low SpO2 alert to set the lower limit of your SpO2 for you to receive an alert
when you are not asleep.
Measuring your skin temperature
Skin temperature measurements are mainly used to monitor the changes in the wrist skin
temperature after exercise. After you enable a continuous skin temperature measurement,
your skin temperature will be continuously measured and a measurement curve will be
generated.
The product is not a medical device. Temperature measurements are mainly used to
monitor the changes in the wrist skin temperature of healthy people over the age of 18
during and after exercise. Results are for reference only and should not be used as a
basis for medical diagnosis or treatment.
During the measurement, wear the device relatively tightly for more than 10 minutes
and stay in a relaxed environment at room temperature (about 25°C). Ensure that
there are no water stains or alcohol on your wrist. Do not start a measurement in an
environment with direct sunlight, wind, or cold/heat sources.
After you exercise, shower, or switch between outdoor and indoor environments, wait
30 minutes before you start a measurement.
Single measurement
In the watch's app list, go to Skin temperature to start measuring your temperature.
Continuous measurement
1
Open the Health app, touch Devices and then the device name, go to Health monitoring,
and enable Continuous skin temperature measurement.
2
In the watch's app list, touch Skin temperature to view the measurement curve.
), and touch this option.
Health Management
29

Advertisement

loading

This manual is also suitable for:

Arc-al00