Learn Mode - M.T.H. RailKing R-12 Subway Set Operator's Manual

2. Learn Mode

In Learn Mode, the engine may be programmed with either an "Out & Back" route or a
"Loop" route. An "Out & Back" route begins at the 1st station (as programmed by the
operator), stops at intermediate stations, ends at the last station, then reverses its route
until it reaches the 1st station. A "Loop" route begins at the 1st station (as programmed
by the operator), stops at intermediate stations, ends at the last station, and then begins
the route over again at the 1st station.
Example Of An Out-and-Back:
Flatbush
Avenue
42nd
Street
Example Of A Loop:
Flatbush
Avenue
To program stations:
1. Running in Forward, stop the unit at the desired location for the first stop by pressing
the direction button. Note: if you stop the engine with the throttle control, you must
re-apply power so that the engine goes into neutral and does not shut down.
RailKing R-12 Subway Set
Wall
Street
Wall
Street
Wall
Street
241st
Street
42nd
Street
Flatbush
Avenue
241st
Street
42nd
Street
7