Table of Contents
Advertisement
7
3
Figure 2
1. Discharge chute
2. Spring
3. Cotter pin, 3/4 in.
4. Washer, 1/2 in.
Important
Discharge chute must be spring loaded in
the down position. Lift chute up to test that it snaps to the
full down position.
Attaching the Adjustable Link
1. Place adjustable link trunnion into rear wheel shaft
bracket and secure with hairpin cotter (Fig. 3).
2
1
Figure 3
1. Adjustable link trunnion
Installing the Mower
1. Park the machine on a level surface, disengage the
power take off (PTO), set the parking brake, and turn
the ignition key to off. Remove the key.
2
4
5
6
1
5. Rubber bushing
6. Plastic washer
7. Jam nut, 3/8 in.
m–3467
2. Hairpin cotter
2. Turn the front wheels fully to the left and raise
attachment lift lever all the way to the latched position;
refer to tractor Operator's Manual.
3. Open front and mid-mount hitches by pushing release
button and moving lock handles forward (Fig. 4).
1
4
Figure 4
1. Front hitch
2. Mid-mount hitch
4. Slide the mower under the chassis from the right side
and align attachment lift with slot in center lever bar
(Fig. 5).
5. Straighten the front wheels, turn Dial-A-Height knob
counterclockwise, all the way, and lower the attachment
lift lever to the mounting position; refer to tractor
Operator's Manual.
6. Place attachment lift pin into slot in center lever bar and
secure with a washer (3/4 in.) and a hairpin cotter
(Fig. 5).
Figure 5
1. Attachment lift
2. Slot-center level bar
7. Rotate front mounting shaft so fork faces up and align
so spacers are between mid-mount hitch plates (Fig. 6).
7
2
3
3
m–2312
3. Release button
4. Lock handle
1
2
3
4
m–2824
3. Washer
4. Hair pin cotter
4
Advertisement
Table of Contents
