5G onBoard Plus - Advanced 5G/WiFi Connectivity System
Code: PF AN NWIFI18
5G onBoard Plus Black - Advanced 5G/WiFi Connectivity System
Code: PF AN NWIFI19
Thank you for purchasing a Scout product. This guide refers to all the 5G/WiFi systems listed above, before installing the router
and the antenna(s) please read carefully all instructions. Customer comments are welcome.
Safety information
Before starting operating the device, please review recommendations and precautions to minimize the possibility of accidents.
Safety precautions presented are supplementary and subject to the local safety regulations. When various operations are executed
on the device, the user must fully follow the safety instructions and recommendations provided with the device.
RF exposure
This device meets the official requirements for exposure to radio waves. This device is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF) energy set by authorized agencies. The device must be used with a
minimum separation of 20 cm from a person's body to ensure compliance with RF exposure guidelines. Failure to observe these
instructions could result in your RF exposure exceeding the applicable limits.
The external antenna must be installed to provide a distance of at least 20 cm from any people and must not be co-located or
operated in conjunction with any other antenna or transmitter.
Router operating conditions
•
Operating temperature: -40° to +75° Celsius
•
Humidity should be in the range of 10% to 90% (non-condensing). Only use the device in dry environments.
•
Out of direct sunlight
•
Away from heat source, corrosive substances, salts, and flammable gases
Faulty and damaged products
•
Do not attempt to disassemble the device or its accessories.
•
Only qualified personnel must service or repair the device or its accessories.
•
If your device or its accessories have been submerged in water punctured or subjected to a severe fall, do not use until they
have been checked at an authorized service center.
Electrical safety
•
Only use approved accessories.
•
Do not connect with incompatible products or accessories.
•
It is recommended to ground devices with grounding terminals before connecting them to power. Failure to ground
appropriately might result in a shock hazard. The cross-sectional area of the protective grounding conductor should be at
least 1mm2.
www.scoutantenne.com
Quick start guide
(v1.23)
Page 1/12