Advertisement
Eyebrow trimming attachment
Depending on your model, Philips nose trimmers can come with eyebrow and detailer combs. The
combs come in the following lengths and designs:
Eyebrow comb S = remaining hair length 3mm or 0.12"
Eyebrow comb L = remaining hair length 5mm or 0.19"
1. Comb your eyebrows in the direction of hair growth.
2. Make sure the product is switched off. Slide the eyebrow comb onto the trimming head. The short
eyebrow comb trims the hair to a length of 3 mm. The long comb can trim the hair to a length of
5mm.
3. Switch on your device.
4. Move the comb over the eyebrow from the outer tip of the eyebrow towards the base of the nose
(against the direction of hair growth).
5. Clean thoroughly after each use.
Detailer trimming
If your product comes with a detail trimming head, you can use this to shape and maintain your
beard, sideburns and neck hair.
To trim most effectively, place the flat part of comb on your skin and move the trimmer slowly and
with light pressure against direction of hair growth.
Detailer combs come in the following lengths and designs:
Detailer comb M = remaining hair length 3mm or 0.12"
Detailer comb L = remaining hair length 5mm or 0.19"
Slide the detailer comb onto the front of detailer trimmer head and push down the back until you
hear a click.
Note: For first time use always use the detail trimming head with its comb. After that you may use
this attachment with or without the comb. Keep in mind that when you use the precision trimmer
without the comb it will trim every hair it touches.
Advertisement
