Voice Operated Transmission (Vox) - Kenwood NEXEDGE NX-248 Instruction Manual

LED INDICATOR STATUS
Indicator Color
blue
Flashes
orange
Flashes
Lights red
Lights green
Blinks red
Blinks green
Blinks orange
or blue *
Blinks red/orange
* Your dealer can set the LED to blink either orange or blue for
FleetSync, DTMF, 2-tone, or NXDN operation.

VOICE OPERATED TRANSMISSION (VOX)

VOX operation allows you to transmit hands-free. This feature
must fi rst be activated by your dealer, and can only be used if
you are using a supported headset. VOX can be turned off for
specifi c channels by your dealer. To activate VOX and set the
VOX Gain level, perform the following steps:
1 Connect a headset to the transceiver.
• The VOX function does not activate when a headset is not
connected to the accessory terminal of the transceiver.
2 With the transceiver power OFF, press and hold the Side 1
key while turning the transceiver power ON.
3 Continue to hold the Side 1 key until a beep sounds.
• The LED indicator lights orange.
• When the Side 1 key is released, the transceiver will announce
the VOX Gain level.
Digital mode
Analog mode
Transmitting
Receiving a call
Battery power is low while transmitting
Scanning & site roaming
Receiving an encoded call (FleetSync
signaling, etc.)
The selected channel has not been
programmed and cannot be used.
Meaning
13