Kenwood NEXEDGE NX-248 Instruction Manual page 12

CHARGING THE BATTERY PACK (OPTIONAL BATTERY
CHARGER)
The battery pack is not charged at the factory; charge it before use.
ATTENTION:
◆ Always switch OFF a transceiver equipped with a battery pack
before inserting the transceiver into the charger.
1 Plug the AC adapter cable into the jack located on the rear
of the charger.
2 Plug the AC adapter into an AC outlet.
3 Match the Holder to the type of battery pack to be charged
so that when inserting the Holder, the battery type name
can be seen on the bottom of the charger. After inserting
the Holder into the charger, press the locking tabs to secure
it in place. <KSC-43 only>
Holder
• To remove the Holder, squeeze the locking tabs
together then pull the Holder out of the charger.
<KSC-43 only>
4 Slide a battery pack or a transceiver equipped with a
battery pack into the charging slot of the charger.
Indicator
4
Li-ion battery
charger
Indicator
Ni-MH battery
charger