Maintenance - EUROM Q-time 2001 Manual

 Only connect the heater to an earthed socket! For personal protection the installation,
to which the Q-TIME 2001 is connected, has to be equipped with an earth fall device
(max. 30 mAmp).
Permanent mounting:
The Q-TIME 2001 is designed for installation in a permanent position and direct connec-
tion to the electricity network. For safety reasons, this installation should be fitted by an
approved electrician.
Plug connection:
The Q-TIME 2001 can also be connected directly to a power socket using the electric ca-
ble and plug. Make sure that the electric cable does not hang over any (sharp) edges,
does not make any sharp angles, cannot be dragged and does not touch any hot surfaces.
Important: the electric cable and plug form a whole. Therefore, if either the electric cable
or plug is damaged they should both be replaced by an electrician. Only mount the original
parts!
 When positioning and connecting the heater, make sure that your hands do not touch
the heating elements. This is because traces can be left behind which, afterwards, will
have a negative effect on the radiated heat.
 For use with a plug, the following applies: do not use extension leads and do not con-
nect any other equipment next to the heater in the same socket!
 Position the mounting bracket (A) with the side with 2 holes against the wall in the re-
quired position, then mark the drill
holes. Make sure that the drill holes are
positioned at the same height! Remove
the bracket and drill 2 holes in the
spots marked. Knock in the raw plugs,
position the bracket over the top and
screw it firmly into the wall using the
screws supplied.
 Place the heater over the bracket with
the cord down and large holes posi-
tioned over large holes. Screw securely
using the bolts and nuts supplied (B).
 Turn the heater to the required posi-
tion. The body of the heater can be
turned to 2 positions (small heater
holes over one of the two small bracket
holes (C)). Secure the heater at the required angle by screwing both of the small screws
into the double holes.
 The heater is now ready for use.
USE
To use the heater, if required insert the plug into the socket and pull on the pull switch.
Each time that you pull the pull switch, the heater will change to the next setting:
0 (off) > 1 (650W) > 2 (1300W)
You are able to view the heater's setting through the peep hole.

MAINTENANCE

Before you perform maintenance on the heater, you have to turn off the power supply.
> 3 (2000W) > 0 etc.
16