Table of Contents
Advertisement
AMPS Technician Programming
The following commands may be used by a trained service technician to
change the configuration of the RAYCOM Cellular . WARNING: these com-
mands are intended for use by trained service technicians only. Untrained
!
users could damage the Raycom, violate local regulations and breach the
service agreement with the cellular provider.
AMPS Technician Programming Commands
The RAYCOM Cellular (AMPS) can be programmed on location with an ordi-
nary telephone, which is sometimes referred to as a POTS (Plain Old Telephone
Set) phone. NOTE: the Technician Programming mode is not accessible
while in a call.
In the following sections, an <entered value> is comprised of the digits 0
through 9. The digits '*' and '#' are considered invalid when used inside an
<entered value>, and will cause that command/value to be rejected.
When you enter the programming mode, a timer is started. If there are no key
entries within any 2-minute period, the FWT will revert to its normal mode.
Going on-hook (hanging up the phone) will exit the programming mode.
How to Enter the Technician Programming Mode
Use the following access code to enter the Programming mode:
Press:
The access code is 8 digits. If the access code is not 8 digits or does not match
the stored access code, the Technician Programming mode cannot be not
entered. This code is pre-programmed during production and cannot be
changed in the field.
If you enter the access code correctly, the dial tone should change to a differ-
ent, steady "Programming" tone and the LED indicator on the front of the
RAYCOM will blink alternately RED and GREEN to indicate that you're in the
programming mode.
RAYCOM C
(AMPS)
ELLULAR
IMPORTANT!
# * 0 * 1 2 3 4 4 3 2 1 #
27
Advertisement
Table of Contents
