Table of Contents
Advertisement
Using an ordinary POTS telephone, program your RAYCOM
as follows:
Step #1 -
Step #2 -
The dial tone should change to a different, steady "Programming" tone and
the LED indicator on the front of your RAYCOM should blink alternately RED
and GREEN to indicate that you're now in the programming mode. You now
have two minutes to begin the programming steps below.
Step #3 -
The spaces represent your 10-digit telephone number. (This is also called a
Mobile Identification Number, or MIN.) If you enter the number incorrectly,
you'll hear three short tones followed by the programming tone; if correct,
you'll hear the programming tone again.
Step #4 -
The spaces represent your 1- to 5-digit System Identifier (SID) , which ranges
from 0 to 32,767. This information identifies your cellular service provider.
(For example, to set up 555, enter #*5*555#.) If you enter the SID incorrectly,
you'll hear three short tones followed by the programming tone; if correct,
you'll hear the programming tone again.
NOTE: Depending upon whether you enter an odd SID or an even SID,
the Raycom will automatically set the remaining NAM parameters to
AMPS standards – as shown in the table below.
Automatically Set NAM Parameters
Initial Dedicated Control Channel
First Paging Channel
Number of Dedicated Control Channels
Preferred System
Roam Option (to override, see page 23)
If you need to override any of the settings, continue with the following steps
(5–8). Otherwise, hang up. The flashing LED indicator will become solid
GREEN. Phone number setup is complete.
RAYCOM C
RAYCOM C
(AMPS)
(AMPS)
ELLULAR
ELLULAR
Pick up the POTS handset and listen for a tone (either a
steady dial tone or a beeping no-service tone).
Enter the Master-Programming mode by pressing:
# * 0 * 1 2 3 4 4 3 2 1 #
Press:
# * 1 * _ _ _ _ _ _ _ _ _ _ #
Press:
# * 5 * _ _ _ _ _ #
STEP 3. PHONE NUMBER SETUP
AMPS Standards
Odd SID
333
333
21
A
Enabled
10
10
Even SID
334
334
21
B
Enabled
Advertisement
Table of Contents
