RAYCOM Operation
Once your RAYCOM Cellular is installed and tested, it's ready for operation.
How to Use the LED Status Indicator
1) Apply power to the unit.
2) As soon as power is applied, the LED status indicator will illumi-
nate. Wait approximately 10 seconds for the unit to initialize.
3) The LED StatusTable below describes the modes and operation of
this 3-color indicator.
LED Status Table
LED Color
RED
RED
YELLOW
GREEN
RED/GREEN
OFF
How to Place a Call
1) Pick up your telephone handset (your phone is now "off-hook").
2) Listen for dial tone (If service is not available, a No-Service tone is
produced. Hang-up the phone and try again.)
3) Dial the phone number.
How to Receive a Call
When your telephone rings, pick up the handset and begin talking.
How to End a Call
Hang-up the phone (place the handset back onto the telephone cradle).
Hookflash Function
When you initiate the Hookflash function, it automatically lets you:
Speed up the connection after you dial a phone number.
• Answer an incoming call that occurs when you're dialing a
phone number.
RAYCOM C
ELLULAR
LED Activity
Flashing
Continuous
Continuous
Continuous
Flashing
None
(AMPS)
Description
Malfunction. Hardware fault detected.
No cellular service.
Moderate cellular signal strength.
Best cellular signal strength.
Diagnostic/programming mode.
No Power.
17