To Transmit The Response By Pressing Ptt Key; “All Ship’s Call” - Raymarine Ray 53 User Manual

---- Channel Display(Large) displays 70CH.
---- "In" is flashing at Channel Display(Small) which means the unit is ready to
receive Individual Ship's Call.
---- "TX" is flashing, which means the unit is ready to receive Individual Ship's Call.

4. To transmit the response by pressing PTT key.

After transmission,the unit will switch to instructed Channel number and DSC
mode will be exited.
---- When DSC mode is exited, "DSC" is eliminated.
---- Channel Display(Large) display the selected Channel number.
---- Channel Display(Small) is eliminated.
5. The transmitter/receiver can be done at the selected channel number.
5) "All Ship's Call"
1. "All Ship's Call" does not specify the other ship.
"All Ship's Call is general call to any ship to initiate contact on channel 16.
Unless "Own Ship's ID" is entered,"All Ship's Call" cannot be done.
2. When SCAN/MEM key and WX/INT key are simultaneously pressed and
released, "All Ship's Call" will be in use.
---- "DSC" is displayed on the LCD which means the unit is in DSC mode.
---- Channel 70 is displayed at Channel Display(Large)
(Programming for PLL data of 70CH.)
---- "In" is displayed at Channel Display(Small) which means the unit is in
Individual Ship's Call mode.
3. "All Ship's Call" can be selected by rotating Channel Selection Knob.
Channel Display(Small) displays "AS".
Whether "Individual Ship's Call" or "All Ship's Call" can be selected by Channel
Selection Knob.