Table of Contents
Advertisement
Part
Water valve
Thermistor
※ Reassembly is in the reverse order of the removal.
All manuals and user guides at all-guides.com
Figure
Description
1. Remove the two (2) screws from the Base.
2. Lift up the inlet valve and disconnect the inlet
valve wire connector.
3. Release the hose clamp and disconnect hose.
C aution
Caution : When removing the hose clamp, take
care to hold it tightly. The clamp is under tension
and if released, it can become a projectile.
C aution
There will be a residual amount of water in the
valve and valve hose. Use a towel to absorb the
water when removing the valve.
Preparation:
•
Disassemble the Cover base.
- Refer the "Cover base" disassembly section.
1. Remove the one (1) screws of Cover base and
pull out the Cover base.
2. Release the two(2) screws of Thermistor.
3. Pull out carefully.
it
: The Thermistor has a seal .
Disassembly and Reassembly _ 23
Hide quick links:
Advertisement
Table of Contents
