Troubleshooting - AEG DGB3850M User Manual

The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first
two steps in reverse order.
Repeat the steps for all filters if applicable.
6.3 Replacing the charcoal filter
The charcoal filter must be replaced if the
filter alarm is on.
Refer to the filter notification in daily use
chapter for more information about
function.
WARNING!
The charcoal filter is NON-washable! The
filter cannot be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate the appliance.
You cannot activate the appliance.
The lamp does not operate.
The appliance does not absorb
enough vapours.
Refer to "Cleaning the grease filter" in this
chapter.
2. Turn the filter counterclockwise (1) and
To mount the filters back follow the steps in
reverse order.
In any case, it is necessary to replace the
filters at least every four months.
6.4 Replacing the lamp
This appliance is supplied with a LED lamp
and separate control gear (LED driver).
These parts can be replaced by a technician
only. In case of any malfunction refer to
"Service" in the "Safety Instructions" chapter.
Possible cause
The appliance is not connected to a
power supply or it is connected in‐
correctly.
The fuse is blown.
The lamp is defective.
The motor speed is not adequate to
the appearing vapours.
58
then pull (2).
Remedy
Check if the appliance is correctly
connected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp. Refer to the
"Care and Cleaning" chapter.
Change the speed of the motor.
1
2