Installing And Connecting The Extractor Hood - Dometic 9107300002 Installation And Operating Manual

CK2000
5.1 Control elements
No. in
fig. 1,
Description
page 3
1 Lamps
2
Fan switch
3
Light switch
4 Grease filter
5 Active carbon filter
6 Installing and connecting the extractor
hood
6.1 Note on the installation position
!
WARNING!
•
It is best to install the extractor hood above the cooking area and
integrate it into a wall-mounted cupboard, where possible.
•
The distance between the gas hob flame and the extractor hood
must total at least 65 cm.
6.2 Opening the extractor hood
➤ Remove the two screws (fig. 2 1, page 4) from the cover (fig. 2 2, page 4) and
remove it.
The filter holder (fig. 3 2, page 4) and the device (fig. 3 1, page 4) are held
together by metal clips (fig. 3 3, page 4) on the two front corners.
➤ Unclip the filter holder by pulling the filter holder and the device apart at the
points marked.
➤ Remove the filter holder (fig. 4 1, page 5) at the points marked.
EN

Installing and connecting the extractor hood

Blower at half speed
Blower at full speed
Off
On /
Off
11