Install The Dell Hba350I Adapter - Dell HBA 355 Series User Manual

3. Locate the HBA350i Adapter in the expansion riser on the system board.
CAUTION: To prevent damage to the card, hold the card by its edges only.
4. Unfasten and lift the riser from the system board. Remove the HBA350i Adapter from the system.
5. Disconnect the SAS cables from the card:
a. Press down and hold the metal tab on the SAS cable connector.
b. Pull the SAS cable out of the connector.
6. Place the storage controller and reconnect the SAS cable before inserting them into the riser.
7. Reinstall the riser on the system board and fasten the riser.
8. Install the system cover.
9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 22. Remove the HBA350i Adapter

Install the Dell HBA350i Adapter

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
● You have read and complied with the safety guidelines listed in
● You have completed the procedures in
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior
of the system.
2. Remove the system cover.
34 Installation and removal of cards
Safety
Before working inside your
instructions.
system.