Install The Dell Hba355E Adapter - Dell HBA 355 Series User Manual

NOTE: For more information about power supply units (PSUs), see the owner's manual of your system
poweredgemanuals.
2. Disconnect the system from the network.
3. Remove the cover of the system.
4. Locate the PCIe slot.
NOTE: To prevent damage to the controller card, hold the card by its edges only.
5. Remove the screws on the bracket, if any, or use the retention clips of the system to remove the controller on the system.
6. Remove the connector that attaches the HBA355e Adapter to the system board.
7. If applicable, replace the storage controller card and connect the cable.
8. Install the system cover.
9. Reconnect the power cables and network cables.
Figure 11. Remove the HBA355e Adapter

Install the Dell HBA355e Adapter

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
● You have read and complied with the safety guidelines listed in
● You have completed the procedures in
Steps
1. Unpack your HBA355e Adapter.
2. Attach the bracket with the card using the screws provided.
3. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
Safety
Before working inside your
instructions.
system.
Installation and removal of cards
www.dell.com/
27