Unpacking The Cooker; Moving The Cooker - Rangemaster Elan 90 Electric User Manual

Rangemaster elan 90 electric: users guide
Hide thumbs Also See for Elan 90 Electric:
Table of Contents

Advertisement

Unpacking the Cooker

Do not take any packaging off the cooker until it is
directly in front of the place it is to be installed (unless
it will not fi t through a door in its outer packaging).
Cut the banding straps and lift the cardboard box off
the cooker, LEAVING THE COOKER STANDING ON
THE BASE PACKAGING. See the loose unpacking
sheet.

Moving the Cooker

The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the fl oor covering is fi rmly fi xed, or
removed to prevent it being disturbed when moving
the cooker around. You will need the levelling tool.
From the back tilt the cooker forward and remove the
rear half of the polystyrene base pack.
Repeat from the front and remove the front half of the
poly base.
LOWER THE TWO REAR ROLLERS.
First fi t the levelling tool on the hexagonal adjusting
nut as shown below.
Make 10 complete (360º) turns clockwise. (This
means turning and removing the levelling tool 20
times).
Make sure you lower BOTH REAR ROLLERS. There
are two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker.
Unfold the rear edge of pack base tray. Open the
grill door and the Tall oven door. Grip under the facia
panel and lift the front of the cooker.
Carefully push the cooker backwards off the pack
base. Remove the pack base tray. Position the cooker
close to its fi nal position leaving just enough space to
get behind it.
Do not use the door handles or control knobs to
manoeuvre the cooker. Use the hotplate and griddle
bowl areas.
Levelling
You are recommended to use a spirit level on a shelf
in one of the ovens to check for level.
Place the cooker in its intended position taking care
not to twist it within the gap between the kitchen units
as damage may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to
level the cooker. To adjust the height of the rear of
the cooker use the levelling tool supplied to turn
the adjusting nuts at the front bottom corners of the
cooker. To set the front feet turn the bases to raise or
lower.
30

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elan 90 ceramic

Table of Contents