Advertisement
Air Leakage
• If after 2 minutes of operation the required negative pressure is not reached, the
vacuum sealer will automatically pause operation.
• The Seal indicator will flash for 3 seconds and then the vacuum sealer will return to
standby mode.
• If air leakage is suspected:
o
Check the seal for any moisture. Wipe it away or cut the bag if necessary.
o
Check if there is a hole or puncture in the bag. Replace the bag if necessary.
o
Check for any wrinkles in the seal. Wrinkles may cause air to re-enter the bag.
Cut the sealed edge and re-seal the bag if necessary.
Cut and Seal a Bag
1.
Open the cover and pull out the bag roll to the desired length.
2.
Firmly close the cover and press the Seal button to seal it.
3.
Cut the bag using the push blade and open the cover.
4.
Complete sealing and make bags.
Push blade
Bag
Seal button
Sealed
bag
10mm
Advertisement
