Home Theater Master MX700 Manual page 25

5 Test the Code Set
A.Verify the MX700 is loaded with fresh batteries and connect the MX700 to the PC via the serial
port.
B.Turn on the Component
C. Point the connected MX700 so that it is in range and within line of sight of the component.
D. Click on the Test button as shown here:
E. Observe the component. If it stays on, click on another Model and continue until you find the
Code Set that turns the component off.When it turns off, Click on Save.
F. If you know the Code Set # from prior experience, enter it in the text box, or use the up and
down arrows to change the code number. If you have to test all of the code sets, this is probably
the fastest way to test all code sets (usually learning codes is much quicker, try that first).
G.After you find the correct Code Set, click on SAVE.When you do, the LCD Button Editor window
pops open. Check the buttons on the original remote and compare to those on the LCD Button
Editor. You can correct any labels that you think could be more user friendly. Feel free to
rearrange buttons as you wish. Moving LCD buttons with the LCD button Editor is exactly like
moving Devices, simply click and drag to an empty location. Once you are reasonably satisfied with
the arrangement, click on the Apply button.
6 Continue with the rest of the devices you need, using the Next Device button to move to the next device
(or manually picking them from the Device list box).
Step by Step Tutorial
19
T
H
E
M
X
7
0
0
D
U
A
L
R
E
M
O
T
E
S
Y
S
T
E
M