Jonsered CS 2166 Workshop Manual page 45

Reassembly
Reassemble the crankcase and crankshaft as follows:
!
WARNING!
The crankcase halves are hot. Risk for
burns. Use protective gloves.
1. If bearings are to be fitted, proceed as follows:
A. Heat the relevant crankcase half to 200°
in an oven.
B. Using protective gloves, take out the crankcase
half and push home the bearing.
NOTE!
Ensure that no dirt or foreign particles enter
the bearings.
D. Refit the rubber stop (A). See fig. 9.
E. Refit the oil filler cap.
2. If replacement crankcase seals are to be fitted,
grease the seal surfaces and tap them home using
tools 502 52 20-01 and 502 52 21-01. See fig. 10.
The seals can also be fitted with the crankshaft in place.
NOTE!
Ensure that the connecting rod does not jam
against the crankcase when the crankcase
and crankshaft are reassembled.
NOTE!
The crankshaft should be fitted into the
clutch half of the crankcase first.
3. Use tool 502 50 30-14 and pull the crankshaft into
the clutch half of the crankcase. See fig. 11. Pull until
the crankshaft shoulder mates with the bearing.
CRANKCASE AND CRANKSHAFT
Fig. 9
Fig. 10
Fig. 11
A
English – 45