Assembly - Husqvarna TS 354 Operator's Manual

Keys
Key(s)
(1) Seat
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 5/16" wrench
(2) 7/16" wrenches
(2) 1/2" wrenches
(2) 9/16" wrench
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
UNASSEMBLED PARTS
(1) Oil Drain Tube
(1) Quick
Connect
Seat
(1) Knob
*Installed by Dealer
*Brush Guard Kit

ASSEMBLY

Utility knife
Tire pressure gauge
Pliers
Slope Sheet
(3) Bolt
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Remove end panels and lay side panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
5
Battery
(2) Hex Bolts
(2) Nut Keps
(1) Cup
(3) Flat
Washer
Washer