Table of Contents
Advertisement
Option Cycle
Delay Wash
You can set a time delay so that the washing machine
will start automatically and finish after a specified time
interval.
1
Press the Power button.
2
Select a washing program.
3
Press the Delay Wash button and set time
required.
4
Press the Start/Pause button.
NOTE
• The delay time is the time to the end of the
program, not the start. The actual running time
may vary due to water temperature, wash load
and other factors.
Turbo Wash™
Adding the Turbo Wash™ option reduces cycle time and
provides good performance in normal cycle. Using Turbo
Wash™ saves time without sacrificing performance.
1
Press the Power button.
2
Select a washing program.
3
Press the Turbo Wash™ button..
4
Press the Start/Pause button.
NOTE
• Turbo Wash™ function of Some courses is
selected automatically.
24
Add Load
Use this function to add loads or remove the foreign
material.
1
Press the Add Load button.
2
Close the door after add loads or remove the
foreign material (e.g. coin or pin etc.)
3
Press the Start/Pause button.
• Results when choosing Add Load during cycles.
- When the tub is spinning : Tub stops and Door Lock
is off.
- When water temperature in the tub is higher than
45°C : Add Load is not available with short warning
sound for safety.
- When lots of water is in the tub : Door Lock is off
after draining by safe water level.
NOTE
• Open the door when Door Lock is off after
checking the safety.
• Add Load doesn't work when Tub Cleaning
course is in progress for safety.
• Put the laundry into the tub completely. Laundry
caught in between door closing part can damage
door packing (rubber part) and might cause failure.
Advertisement
Table of Contents
