Electric Reverse (If Equipped) - Motor Trike GTX-1200 Owner's Manual

In order to properly install the draw bar:

Loosen the bolt located on the bottom of the receiver tube.

Slide the draw bar into the receiver tube.

Insert the draw bar pin through the receiver tube and the hole in the draw bar.

Clip the safety pin into the groove in the draw bar pin.

Tighten the bolt supplied under the receiver tube against the draw bar to prevent it from rattling.
DRAW BAR

ELECTRIC REVERSE (IF EQUIPPED)

If used within the recommendations below, the electric reverse will meet all of your expectations.
Before reversing, always check that the path behind the trike is clear and announce that you are backing
up to anyone nearby. Be sure to follow these guidelines will using your reverse:
Revision 3
DRAW BAR PIN
Figure 5: Draw Bar Components
RECIEVER
TUBE
Figure 6: Properly Installed Draw Bar Safety Pin
DRAW BAR
SAFETY PIN
PROPERLY
INSTALLED DRAW
BAR WITH SAFETY
CLIP
ANTI-RATTLE BOLT
Page 9 of 14