Air Suspension Operation - Motor Trike GTX-1200 Owner's Manual

AIR SUSPENSION OPERATION

An on-board air compressor allows for on-the-fly air suspension pressure adjustment. The
pressure is adjusted using the suspension control module mounted to the handle bars. To increase air
spring pressure, press and hold the "UP" button until the desired pressure is reached. To reduce the
pressure, press the "DOWN" button. DO NOT OPERATE THE VEHICLE WITH LESS THAN 15 PSI
OR MORE THAN 100 PSI IN THE AIR SPRINGS. Figure 2 shows the suspension control module.
SUSPENSION
CONTROL MODULE
In order to ensure proper tire wear, ground clearance, and handling characteristics please follow
the guidelines listed on the sticker found on the interior of the trunk and/or top of gas tank. These
guidelines are set in order to ensure the riders' safety and comfort. The sticker is shown in Figure 3
below:
The suspension control module also displays the voltage of the 12v system. The acceptable range
for your vehicle's voltage is between 11V and 14V. If the displayed voltage is greater than 14 volts,
contact your local Motor Trike dealer to have the electrical system inspected on your vehicle. If the
Revision 3
UP
DWN
Figure 2: Suspension Control Module
Figure 3: Air Spring Pressure Sticker Trunk Location
VOLTAGE (V)
PRESSURE (PSI)
Page 6 of 14