Table of Contents
Advertisement
Pairing with
-equipped Devices
If you wish to connect your Bluetooth-equipped device to the instrument via Blue-
tooth, the device needs to be paired with the instrument first.
Once the Bluetooth-equipped device has been paired with this instrument, there is no
need to perform pairing again.
1
Hold down [FUNCTION] for 3 seconds.
The instrument will enter into Pairing mode. At the same time the
lamp will flash and "
bt
ing, press [
/
] (Play/Pause).
>
o
2
On your
to on and select "N1X" from the connection list.
For details, refer to the Bluetooth-equipped device owner's manual.
After pairing is completed, the
will disappear and the display will turn dark.
3
Play back audio data on your
the built-in speakers of the instrument can output the audio sound.
When you turn on the instrument the next time, the last connected Bluetooth-
equipped device will be connected to this instrument automatically, if the Bluetooth
function of the device and the instrument is set to on. If it is not connected automati-
cally, select the model name of the instrument from the connections list on the device.
Switching the
By default, the Bluetooth function will be set to on right after turning the instrument's power on. However, you can
set the function to off when you want to disconnect the connection between the instrument and the Bluetooth-
equipped device, or when you want to try to connect the device to the instrument again, etc.
While holding down [FUNCTION], press the F6 key repeatedly (if necessary).
" message will appear on the display. To cancel the pair-
Flashes.
Appears on the display.
-equipped device, set the
(Bluetooth) lamp will light up and the message
-equipped device to confirm that
Function On/Off
(Bluetooth)
bt
function
Highest key (C7)
F6
Connections
Pairing
"Pairing" means to register
-
equipped devices on this instrument, and
establish the mutual recognition for wire-
less communication between the two.
NOTE
Only one
-equipped device can be
connected to this instrument at a time
(although up to 8 devices can be paired to
this instrument). When pairing with the 9th
-equipped device has succeeded,
pairing data for the device with the oldest
connection date will be deleted.
NOTE
When the
function of this instru-
ment is set to "Off," standby for pairing with
the instrument is not enabled when holding
[FUNCTION] for 3 seconds. In this case, set
to "On" (See below.), and then
start pairing.
NOTE
• Make sure to complete the settings on
the
-equipped device within 5
minutes. After 5 minutes passed, the
Pairing mode ends automatically and the
(
) lamp turns off.
• If you are required to enter a passkey,
enter the numerals "0000."
NOTE
You can adjust the volume of the sound
input via
by the [MASTER VOL-
UME] control. To adjust the volume balance
between your keyboard performance and
the input sound via
, adjust the
volume on the
-equipped device.
N1X
• 41
Owner's Manual
Advertisement
Table of Contents
