Craftsman 580.752100 Operator's Manual page 12

3. ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to release retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
4. Engage trigger lock on spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and PrecisionSpray™ Selector. There is
also a hook at the front of the accessory tray to hold your
high pressure hose. Identify all accessories with the
illustration on page 6.
NOTE: The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo nozzle. The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place PrecisionSpray™ Selector through hole on
accessory tray, as shown.
2. Place spray gun through hole on accessory tray on right
side of unit.
3. Hang high pressure hose on hook attached to accessory
tray on front of tray as shown.
WARNING
How to Use PrecisionSpray™ Selector
Refer to the PrecisionSpray™ Selector instruction sheet for
proper use.
Product damage will occur if the gun trigger is squeezed
while the Selector is in-between nozzle settings.
• NEVER turn the Selector while spraying.
Cleaning and Applying Detergent
Chemicals can cause bodily injury, and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent follow these steps:
1. Attach one of the detergent siphon hoses following
instructions Attach Detergent Siphon Hose to Pump.
IMPORTANT: Be sure engine is off and allowed to cool before
switching detergent siphoning hoses.
Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
2. Prepare detergent solution as required by job.
3. Make sure detergent shut-off valve on cleaning tank is in
"Off" position.
4. If using cleaning tank, pour detergent into cleaning tank.
NOTE: The cleaning tank holds one gallon.
5. Rotate PrecisionSpray™ Selector to a low pressure
position, as described in the PrecisionSpray™ Selector
instuction sheet.
NOTE: Detergent cannot be applied with the PrecisionSpray™
Selector in a high pressure position.
6. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray gun
and pump. Turn on water.
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
12
NOTICE
CAUTION
WARNING
NOTICE