General Chassis; Removing The Seat; Removing The Number Plate - Yamaha YZ250FX 2023 Owner's Manual

EAM20094

GENERAL CHASSIS

EAM30016

REMOVING THE SEAT

TIP
The fuel tank cap cover and the seat are coupled
with each other with a plastic band.
When removing the seat, always remove the
fuel tank cap cover beforehand.
1. Remove:
• Fuel tank cap cover "1"
Refer to "FUEL TANK CAP" on page 1-14.
2. Remove:
• Seat "1"
3. Check:
• Seal "1"
Damage/wear/detachment  Replace.
1 1 1
4. Replace:
• Seal "1"
TIP
• Install the new seal in the original position.
1
1
• Make sure that the new seal does not cover the
ducts "2".
2 2 2
EAM30371

REMOVING THE NUMBER PLATE

1. Remove:
• Bolt (number plate)
• Number plate "1"
TIP
• The projection "a" is inserted into the band of
the number plate. Pull the band off the projec-
tion before removal.
• Remove the clutch cable "2" from the cable
guide "b" on the number plate.
• The projection "c" on the lower bracket is in-
serted into the number plate. Remove the
number plate by pulling it off the projection.
• When installing the number plate, insert the
projection on the number plate into the hole in
the upper side of the band.
4-1
GENERAL CHASSIS
1