Caring For Your Floors; Charging Your Machine; Changing Your Click-In Battery - Dyson Gen5 Detect User Manual

Caring for your floors

Check that the underside of the cleaner head or tool is clean and free from
any objects that may cause damage.
Before vacuuming your flooring, rugs, and carpets, check the manufacturer's
recommended cleaning instructions.
The brush bar on your machine can damage certain carpet types and floors.
Some carpets will fuzz if a rotating brush bar is used when vacuuming. If this
happens, we recommend vacuuming without the motorised floor tool and
consulting with your flooring manufacturer.

Charging your machine

You can use your machine immediately, or charge it partially,
without the need to fully charge before first use.
Connect to the charger, either directly or in the dock.
The blue LEDs on both sides of the battery will flash during charging.
When the battery is fully charged, both LEDs will light for five seconds.
Your battery is fully charged when the display shows 100%.
Your machine won't operate or charge if the ambient temperature is below
5°C (41°F). This is designed to protect both the motor and battery.

Changing your click-in battery

If you have additional click-in batteries, we recommend that you alternate
the batteries to maintain even performance.
Removing your battery
Push the Battery release button at the front of the battery unit, and slide the
battery off your machine.
Charge the battery.
Refitting your battery
Align your battery with the handle and slide it in. Push firmly until it clicks
into place.
The charger connected from the
power supply using the wall dock.
1 00%
The charger connected from
the power supply directly
into the front of the battery.
Arrows showing the location of the Battery release button at the
front of the battery unit, and the battery coming off the handle
when the button is pressed. The battery is then shown being
replaced on the base of the handle, clicking into place.
click
clik