Cleaning The Appliance - Bosch KI20F Series User Manual

en

Cleaning the appliance

ã=
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers
■
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse.
3. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. Rinsing water must not run through
the drainage hole into the evaporation
area.
6. After cleaning reconnect and switch
the appliance back on.
Notes
Regularly clean the condensation
■
channel and drainage hole, Fig. +,
with a cotton bud or similar implement
to ensure that the condensation can
drain.
After cleaning, the stopper must be re-
■
inserted into the drainage hole of the
refrigerator compartment for functional
reasons.
28
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. 3
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Take out shelves in the door
Fig. 4
Lift shelves upwards and take out.
Removing the container
Fig. ,
Pull out the container all the way and lift
to detach it.
To insert the container, place on the
telescopic rails and push into the
appliance. Attach the container by
pressing it down.
Taking out the humidity filter
Fig. 1/9
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. -, and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
Installing extension rails
Fig. .
1. To remove the extension rails, bend
slightly at the front in the direction of
the arrow.
2. Lift extension rail and detach from the
mounting.
3. To install the extension rail, insert into
the rear opening.
4. Insert extension rail into the front
opening and engage downwards.