Positioning The Cooker; Moving The Cooker - Rangemaster Infusion-90 User's Manual & Installation Instructions

Positioning the Cooker

Fig. 8.1 and Fig. 8.2 show the minimum recommended
distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hotplate surround should be level with, or above,
any adjacent work surface. A gap of 75 mm should be left
between each side of the cooker ABOVE the hotplate level
and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hob and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for
the additional height of the flue trim, which is fitted to the
cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
cooker to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
We recommend a gap of 910 mm between units (920mm for
induction cookers) to allow for moving the cooker. DO NOT
box the cooker in – it must be possible to move the cooker in
and out for cleaning and servicing.
If the cooker is near a corner of the kitchen, a clearance of
130 mm is required to allow the oven doors to open (Fig. 8.3).
The actual opening of the doors is slightly less, but this allows
for some protection of your hand as you open the door.

Moving the Cooker

On no account try and move the cooker while it is
n n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n n
We recommend two people manoeuvre the cooker. Make
sure that the floor covering is firmly fixed, or removed to
prevent it being disturbed when moving the cooker around.
To help you, there are two levelling rollers at the back and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt
the cooker backwards and remove the front half of the
polystyrene base (Fig. 8.4). Repeat from the back and remove
the rear half of the polystyrene base.
INSTALLATION
Check the appliance is electrically safe when you have finished.
ArtNo.090-0017 - 90 6BC min positions above cooker
410 mm min.
5 mm
ArtNo.090-0024 - 90 induction door clearances
25
75 mm min 650 mm min 75 mm min
Height to Flue Trim
905 mm min
930 mm max
900 mm min.*
5 mm
**
130 mm min
Fig. 8.1
Height to
Hotplate
905 mm
min
930 mm
max
Fig. 8.2
Fig. 8.3
Fig. 8.4