Disassembly
Part
Assy Panel Control
(LED)
This Document can not be used without Samsung's authorization.
Figure
Description
- Before you start, disassemble Assy Cover Top, Assy
Drawer.
1. Remove cover screw and then 1 screws holding
the Panel control using (+) screw driver.
2. Slide the Assy Cover Panel about 10mm to the
left and pull it forward.
3. Hold the Assy Cover Panel while pulling it
upwards and disassemble the terminal to remove
it. Press the hook while removing the terminal.
4. Connect the terminal by hand. Take a look at
the hook and put it in the right place.
Make sure the Wire harness are not getting
stuck in other parts.
Disassembly and Reassembly _ 14